Hp Smartmemory; Dimm Identification - HP ProLiant DL320e User Manual

IMPORTANT:
to mix any combination of these DIMMs can cause the server to halt during BIOS initialization.
The server memory subsystem supports UDIMMs only. UDIMMs represent the most basic type of memory
module and offer lower latency and (relatively) low power consumption, but are limited in capacity.
The server supports dual-rank, PC3-10600E/PC3-12800E (DDR3 ECC) DIMMs operating at 1333 or 1600
MHz speed.
Depending on the processor model and the number of DIMMs installed, the memory clock speed might be
reduced to 1333 or 1066 MHz. For more information, see "General DIMM slot population guidelines (on
page 46)."

HP SmartMemory

HP SmartMemory, introduced for Gen8 servers, authenticates and unlocks certain features available only on
HP Qualified memory and verifies whether installed memory has passed HP qualification and test processes.
Qualified memory is performance-tuned for HP ProLiant and BladeSystem servers and provides future
enhanced support through HP Active Health and manageability software.
Certain performance features are unique with HP SmartMemory. The industry supports UDIMM at 2 DIMMs
per channel at 1066 MT/s. HP SmartMemory supports 2 DIMMs per channel at 1333 MT/s, or 25% greater
bandwidth.

DIMM identification

To determine DIMM characteristics, use the label attached to the DIMM and the following illustration and
table.
Item Description
Size
1
Rank
2
This server does not support mixing LRDIMMs, RDIMMs, or UDIMMs. Attempting
Definition
—
1R = Single-rank
2R = Dual-rank
3R = Three-rank
4R = Quad-rank
Hardware options installation 45