Installation Steps; Jumpers; Midi Environment Variable; Maximum Recording Rates For The Audio Hardware - Asus VX97 User Manual

Installation Steps

Before using your computer, you must complete the following steps:
1. Set Jumpers on the Motherboard
2. Install Memory Modules
3. Install the Central Processing Unit (CPU)
4. Install Expansion Cards
5. Connect Ribbon Cables, Cabinet Wires, and Power Supply
6. Setup the BIOS Software

1. Jumpers

Several hardware settings are made through the use of jumper caps to connect jumper
pins (JP) on the motherboard. See "Map of the Motherboard" on page 4 for loca-
tions of jumpers. The jumper settings will be described numerically such as [----],
[1-2], [2-3] for no connection, connect pins 1&2, and connect pins 2&3 respec-
tively. A "1" is written besides pin 1 on jumpers with three pins. The jumpers will
also be shown graphically such as
pins 2&3. Jumpers with two pins will be shown as
Open (Off). For manufacturing simplicity, the jumpers may be sharing pins from
other groups. Use the diagrams in this manual instead of following the pin layout on
the board. Settings with two jumper numbers require that both jumpers be moved
together. To connect the pins, simply place a plastic jumper cap over the two pins as
diagramed.
WARNING: Computer motheboards and components contain very delicate
Integrated Circuit (IC) chips. To protect the motherboard and other
components against damage from static electricity, you should follow some
precautions whenever you work on your computer.
1. Unplug your computer when working on the inside.
2. Hold components by the edges and try not to touch the IC chips, leads, or
circuitry.
3. Use a grounded wrist strap before handling computer components.
4. Place components on a grounded antistatic pad or on the bag that came with
the component whenever the components are separated from the system.
12
III. INSTALLATION
to connect pins 1&2 and
ASUS VX97 User's Manual
to connect
for Short (On) and for