Diskette Configuration Submenu - Intel D845GVSR - Desktop Board Motherboard User Manual

Primary/Secondary IDE Master/Slave Submenus
Feature Options
Drive Installed No options
Type • Auto
• User
Maximum Capacity No options
LBA/Mode • Disabled
• Auto
Block Mode • Disabled
• Auto
PIO Mode • Auto
• 0/1/2/3/4
DMA Mode • Auto
• SWDMA 0/1/2
• MWDMA 0/1/2
• UDMA 0/1/2/3/4/5
S.M.A.R.T. • Auto
• Disabled
• Enabled
Cable Detected No options

Diskette Configuration Submenu

Feature Options
Floppy A • Disabled
• 360 KB 5 1/4"
• 1.2 MB 5 1/4"
• 720 KB 3 1/2"
• 1.44 MB 3 1/2"
• 2.88 MB 3 1/2"
Description
Displays the type of drive installed.
Specifies the IDE configuration mode for IDE devices. User allows
capabilities to be changed. Auto fills-in capabilities from ATA/ATAPI
device. Maximum Capacity No options Displays the capacity of the
drive.
Displays the capacity of the drive.
Selects the translation mode for the IDE hard disk. (This item is read-only
unless Type is set to User.)
Disabled = Data transfers to/from the device occur one sector at a time.
Auto = Data transfers to/from the device occur multiple sectors at a time
if the device supports block mode transfers. (This item is read-only unless
Type is set to User.)
Specifies the PIO mode. (This item is read-only unless Type is set to User.)
Specifies the DMA mode for the drive.
Auto = Auto-detected
SWDMAn = Single Word DMAn
SWDMAn = Multi Word DMAn
UDMAn = Ultra DMAn
(This item is read-only unless Type is set to User.)
Enables/disables S.M.A.R.T. (Self-Monitoring, Analysis, and Reporting
Technology). (This item is read-only unless Type is set to User.)
Displays the type of cable connected to the IDE interface: 40-conductor
or 80-conductor (for ATA-100 peripherals).
Description
Specifies the boot sequence from the available devices.
Using the BIOS Setup Program
2-7