Chassis Intrusion Connector - Asus P8H61-M PLUS V3 User Manual

2. ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
P8H61-M PLUS V3
P8H61-M PLUS V3 ATX power connectors
• For a fully configured system, we recommend that you use a power supply unit (PSU)
• DO NOT forget to connect the 4-pin ATX +12V power plug. Otherwise, the system will
• We recommend that you use a PSU with higher power output when configuring a
• If you are uncertain about the minimum power supply requirement for your system,
3. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
P8H61-M PLUS V3
P8H61-M PLUS V3 Chassis intrusion connector
1-18
ATX12V
that complies with ATX 12 V Specification 2.0 (or later version) and provides a minimum
power of 350 W.
not boot up.
system with more power-consuming devices. The system may become unstable or may
not boot up if the power is inadequate.
refer to the Recommended Power Supply Wattage Calculator at http://support.asus.
com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for details.
EATXPWR
+3 Volts GND
+5 Volts
+12 Volts
+12 Volts +5 Volts
+5V Standby +5 Volts
Power OK -5 Volts
GND GND
PIN 1
+5 Volts GND
GND
GND
+5 Volts PSON#
GND GND
+3 Volts -12 Volts
+3 Volts +3 Volts
PIN 1
CHASSIS
ASUS P8H61-M PLUS V3