HP D7171A - NetServer - LPr Manual page 2

Server Configuration
Parameter
Number of power
supplies
I/O slots
Default boot order
Local Storage
Controller
Driver
Physical drive location
Disk drives
SCSI bus
SCSI IDs
System software
Navigator CD-ROM
Operating system
Service pack
HP Surestore Auto Path VA Version 1.03.00 or later.
Shared Storage Configuration
Parameter
Controller
Model
Number of controllers
Driver
Registry settings
One standard, two required for redundancy
Note that in configurations with fully populated PCI or hard drive slots, the
second power supply is required, and not redundant.
Added cards may be installed in any appropriate slot, considering the server
default boot order provided below.
IDE CD-ROM, FDD, PCI slot 1, PCI slot 2, PCI slot 3, embedded SCSI
Embedded SCSI or NetRAID-1M
For embedded SCSI, use sym_u3.sys, version 5.07.00, or later.
For NetRAID-1M, use mraid2k.sys, version 5.20 or later.
(drivers obtained from Navigator CD-ROM, version L.20.00, or later)
Server internal drive bays, or HP external drive cabinet
(e.g., HP Rack Storage/12)
Must be HP
Any HP cables that meet SCSI specifications, and any SCSI bus speed
Any
Version M.04.00, or later
Microsoft Windows 2000 Advanced Server
Latest service pack
Required only if two Fibre Channel Host Bus Adapters are configured for
shared storage. No Load Balancing is set for the FC HBA devices on each
node. See the dual HBA diagrams on pages 5 and 6 for more information.
HP D8602B Fibre Channel Host Bus Adapter
One or two
Dual HBA controller configurations require running HP Surestore Auto Path VA.
Note that the purpose of the second HBA is to provide an alternate path for
automatic failover only.
Afcw2k.sys, version 3.0.4107.0 (driver obtained from Navigator CD-ROM,
version M.04.00, or later)
N_Port enabled for Fabric configurations
NL_Port enabled for Arbitrated Loop configurations
Refer to the readme file included with the HBA driver for instructions on
modifying driver parameters.
Specification
Specification
3/8/02
lp2000r2k71/74
2