Installing Replica For Novell Netware 4.2 - HP D6030A - NetServer - E50 Getting Started

Chapter 3
If you used the Installation Assistant feature of the HP NetServer Navigator CD
to install NetWare 4.2, your STARTUP.NCF file will probably contain a load
statement that reads "LOAD AIC78XX.DSK ..." which means that your system
is DDFS-based, or "LOAD AHA2940.HAM ..." which means that your system is
NWPA-based. If you don't see one of these LOAD statements, look for a LOAD
statement where the file name extension for the file is .DSK or .HAM.
Press ESC to close the STARTUP.NCF file window.

Installing Replica for Novell NetWare 4.2

There are two options for installing Replica for Novell NetWare 4.2.
Install using the HP SureStore CD's graphical interface.
Install using the Replica SETUP.EXE program.
To install Replica on an HP NetServer running Novell NetWare 4.2 using the
HP SureStore CD's graphical user interface:
1. From an administration PC running Windows 95 or Windows 98, log in
to the server as supervisor (or as a user with equivalent privileges).
2. Map a drive letter to the HP NetServer's SYS volume.
3. Insert the HP SureStore Tape CD-ROM in the administration PC's CD-
ROM drive.
4. If you have the autorun feature enabled on your PC, the HP SureStore
Tape CD installer will start up. Select the language, select "Install
Software", and then follow the on-screen prompts to complete the
installation.
To install Replica on an HP NetServer running Novell NetWare 4.2 using the
SETUP.EXE program:
If you do not wish to use the graphical user interface, you can install Stac Replica
by running the appropriate SETUP.EXE file from the \stac directory on the HP
SureStore Tape CD-ROM. Once the Setup utility is running, follow the on-screen
instructions for completing the installation.
To install the NWPA version:
For the English version, execute SETUP.EXE from the
\stac\eng_nwpa directory.
For the French version, execute SETUP.EXE from the \stac\fre_nwpa
directory.
Installing Replica
11