Registration; Unregister The Handsets; Restore Default Settings - RCA 2102 User 's guide User Manual

is 0000. The maximum length of the Master PIN is 8 digits.
Note: If you forget your PIN code, you can reset it to its default
0000 using a handset reset.
1 Press MENU.
2 Select [ADVANCED SET] >[PIN], then press [OK].
3 Enter the current Master PIN when prompted and then press OK key to
confirm. As you enter the PIN it will be shown as asterisks (*) on the screen.
4 Enter the new PIN and then press OK key to confirm.
5 The setting is saved.

Registration

You can register additional handsets to the base station. The base station can
register up to 4 handsets.
1 Press MENU on the handset .
2 Select [ADVANCED SET] > [REGISTRATION], then press [OK] to confirm.
3 Press and hold on the base station for 5 seconds until you hear a
confirmation beep.
4 Enter the system PIN. Press [BACK] to make corrections.
5 Press [OK] to confirm the PIN.
»» Registration is completed in less than 2 minutes. The base automatically
assigns a handset number to the handset .
Note
•• If the PIN is incorrect or no base is found within a certain period, your
handset displays a notification message. Repeat the above procedure if
registration fails.

Unregister the handsets

1 If two handsets share the same base station, you can unregister a handset
with another handset .
2 Press MENU.
3 Select [ADVANCED SET] > [UNREGISTER], then press [OK] to confirm.
4 Select the handset number to be unregistered.
5 Press [OK] to confirm.
»» The handset is unregistered.
Tip
• The handset number displays beside the handset name in standby mode.

Restore default settings

You can reset your phone settings to the original factory settings.
1 Press MENU.
2 Select [ADVANCED SET] > [RESET], then press [OK] to confirm.
17