Keurig Platinum B70 Owner's Manual page 8

Cleaning & Maintenance (continued)
SECTION 3
2. Cleaning the Funnel — The Funnel can be
19
fig.
removed from the K-Cup Pack Holder by
®
pulling on it until it pops off (fig. 19). The Funnel
is dishwasher safe. To replace it, just snap it
back onto the K-Cup Pack Holder Assembly.
®
3. Cleaning the Exit Needle — The Exit Needle is
!
located on the inside bottom of the K-Cup
Holder Assembly. Should a clog arise due to
coffee grinds, it can be cleaned using a paper
clip or similar tool. Remove K-Cup Pack Holder
®
Assembly and detach Funnel. Insert the paper
clip (fig. 19) into the Exit Needle to loosen the
clog and push it out. The K-Cup Pack Holder is
®
dishwasher safe.
CAUTION: There are sharp
needles that puncture the K-Cup pack above the K-Cup Pack Holder and in
® ®
the bottom of the K-Cup Pack Holder. To avoid risk of injury, do not put your
®
fingers in the K-Cup ® Pack Assembly Housing.
Cleaning the Water Reservoir & Water Reservoir Lid
The Water Reservoir Lid and Water Reservoir should be periodically
inspected and cleaned.
The Water Reservoir Lid or Water Reservoir should not be put into the
dishwasher. They should be cleaned with a damp, soapy, non-abrasive
cloth and rinsed thoroughly. Do not dry the inside of the Water Reservoir
with a cloth as lint may remain.
To clean the filter screen at the base of your Water Reservoir, empty the
Water Reservoir and follow one or all of the following procedures.
NOTE: If you are using a water filter inside the Water Reservoir, remove it
before cleaning.
1. Rinse the filter screen with the strong force of water from your faucet.
If you have a sprayer, aim the water spray at the filter screen.
2.
3. Fill the Water Reservoir with approximately two inches of clean water and
agitate (shake) the Water Reservoir.
Empty the Water Reservoir then fill it with clean water and return it to the
Brewer. If needed, repeat above procedures. CAUTION: Please rinse the Water
Pack
® Reservoir thoroughly after cleaning. This will ensure that no cleaners or cleaning
solutions remain as they may contaminate the water supply in the Brewer.
De-Scaling Your Brewer
Mineral content in water varies from place to place. Depending on the
mineral content of the water in your area, calcium deposits or scale may
build up in your Brewer. Scale is non-toxic, but left unattended, it can hinder
Brewer performance. De-scaling your Brewer
helps maintain the heating element and other
20
fig.
internal parts of the Brewer that come in contact
with water.
The Brewer should be de-scaled every 3-6
months to ensure optimal performance. It is
possible for calcium deposits to build up faster,
making it necessary to de-scale more often.
You should promptly de-scale if "DE-SCALE" is
indicated on the LCD Control Center (fig. 20).
However, even if "DE-SCALE" is not indicated,
you should continue to de-scale your Brewer
every 3-6 months. Properly follow the de-scaling
procedure described on page 15.
14
De-Scaling Instructions
A. PREPARE
Step 1: To begin, you will need the following:
At least 48 oz. of undiluted white vinegar
Access to an empty sink
A large ceramic mug (do not use a paper cup)
Step 2: Empty the water from the Water Reservoir.
Step 3: Disable "Auto Off" features.
B. FILL AND CLEAN
Step 1: Pour approximately 48 oz. of the vinegar into the Water Reservoir.
Step 2: Place a large mug on the Drip Tray Plate and run a cleansing brew.
DO NOT USE A K-CUP PACK, just press the BREW Button. Pour
®
the contents of the large mug into the sink.
Step 3: Repeat the brew process without a K-Cup ® pack until "ADD WATER"
is indicated.
Step 4: Now let the Brewer stand for at least 4 hours while still on.
Step 5: Discard any residual vinegar and rinse the Water Reservoir thoroughly.
C. RINSE
Step 1: Ensure the Water Reservoir is filled with fresh water.
Step 2: Place a large mug on the Drip Tray Plate and run a cleansing brew.
Pour the contents of the large mug into the sink.
Step 3: Repeat brew process until "ADD WATER" is indicated.
Step 4: You may need to perform additional cleansing brews if you notice
any residual taste.
NOTE: If "DE-SCALE" is still indicated after completing the procedure,
repeat the de-scaling procedure above.
Service
Beyond these recommended cleaning and maintenance procedures, this
Brewer is not user serviceable. For service, please refer to the Warranty
section of this guide.
Storage
Empty the Water Reservoir before storing, and take care to ensure that you
store your Brewer in a safe and frost free environment. Please be sure to
store your Brewer in its upright position to avoid water leakage from the
inner tank. If you store the Brewer in a cold environment, you run the risk of
water freezing inside the Brewer and causing damage. When you prepare to
use it after storage, we recommend rinsing the Water Reservoir with fresh
water and running three cleansing brews without a K-Cup ® pack.
If you plan to move your Brewer to a different location, turn the Brewer
off, unplug it, and empty the Water Reservoir. If your Brewer has been in
an environment below freezing, please be sure to let it warm to room
temperature for at least 2 hours before using.
Transport Brewer in the upright position to ensure inner tank does not leak
through vent.
15