Keurig Platinum B70 Owner's Manual page 5

Set-Up & First Brew (continued)
SECTION 1
c. Once size is chosen, press BREW Button.
BREW Button will stop flashing, Left and Right
Buttons will no longer be lit and icon
Extra-Small Cup
of brew size will be lit.
(3.25 oz.)
Large Mug
(9.25 oz.) 7. The LCD Control Center will now indicate
Small Cup "BREWING" and the cup size you selected will
(5.25 oz.)
be illuminated on the LCD Control Center
(fig. 8). CAUTION: There is extremely hot water
Travel Mug
(11.25 oz.)
in the K-Cup Pack Holder during the brew
®
Small Mug
(7.25 oz.) process. To avoid risk of injury, do not lift the
Handle or open the K-Cup ® Pack Assembly
Housing during the brew process.
8. There may be a short pause prior to coffee
being dispensed. The entire brew process
8
fig.
lasts for approximately 1 minute and ends
with a burst of air to remove all liquid from
the K-Cup ® pack.
Lift the Handle,
BREWING 9.
remove and dispose of
the used K-Cup ® pack.
CAUTION: K-Cup
MENU ®
pack will be hot.
MENU
Enjoy your first cup
10.
of Keurig Brewed
®
BREW
gourmet coffee, tea
or hot cocoa!
11. Your Brewer may indicate "NOT READY" as it heats water for the next
brew cycle. The "READY TO BREW" indication will return to the LCD
Control Center in about 15 seconds.
Stopping the Brew Process
If you need to stop the brewing after the process has started, press and
release the Power Switch to turn the Brewer "OFF." The flow of coffee, tea
or hot cocoa will stop, the heating element will shut off and the blue lights
illuminating the LCD Control Center and Water Reservoir will disappear.
NOTE: You may get more coffee, tea or hot cocoa in your cup during your next
brew. We recommend that you perform a cleansing brew after a terminated
brew. Then your NEXT brew will be the volume you have selected.
adding Water
9
fig.
The LCD Control Center will indicate "ADD
WATER" when the water level in the tank is
READY
NOT
low or if the Water Reservoir has been removed
ADD
(fig. 9). The blue light in the Water Reservoir will
WATER
also blink when water needs to be added. The
Brewer will not allow you to brew when "ADD
MENU
WATER" is indicated (fig. 9).
MENU
BREW
8
The Water Reservoir can be filled in two ways.
Open the Easy-Fill Lid and pour water directly into the Water Reservoir
1.
while it is still attached to the Brewer, then close the Lid. The entire
Water Reservoir Lid may be removed completely, if preferred.
2. Remove the Water Reservoir from Brewer by first removing Lid from the
Water Reservoir, then lifting the Water Reservoir straight up and toward
front of Brewer. Fill with water. Place the Water Reservoir back on the
Brewer and replace the Lid. IMPORTANT: Do not remove the Water
Reservoir during the brewing process.
Brewing Iced Beverages
Your iced tea and iced coffee taste best when fresh-brewed hot over ice.
Try it by placing a tall cup filled with ice on the Drip Tray Plate (the Drip Tray
Assembly can be removed to accommodate taller cups), choose your favorite
K-Cup pack, select the brew size and press the BREW Button. Also, look for
®
the Brew Over Ice icon on K-Cup packs specially crafted to brew over ice!
™ ®
IMPORTANT: Do not brew into a cup made of glass. Doing so may cause the
glass to crack or break.
Brewing Hot Water
Your Brewer is able to produce hot water for making hot cocoa from a packet,
for use in cooking, for making soups, etc. Simply follow the instructions on
page 7 — "Ready To Brew Your First Cup" without adding a K-Cup ®
NOTE: After brewing a hot cocoa K-Cup pack, we recommend running a
®
cleansing brew without a K-Cup ® pack.
Purging the Brewer
If your Brewer has not been used for more than one week, you should purge
the water from the inner tank.
1. If there is water in the Water Reservoir, remove the Lid, then lift the
Water Reservoir straight up and away from Brewer. Discard water, rinse
and refill with water. Place the Water Reservoir back on the Brewer and
replace the Lid. (If there is no water in the Water Reservoir, simply refill.)
2. Be sure the Brewer is turned on. Raise and lower the Handle on the
Brewer without inserting a K-Cup pack.
®
The LCD Control Center will indicate "READY TO BREW." Brew a Travel
3.
Mug (11.25 oz. serving) of water (do not use a K-Cup
4. Repeat steps 2 and 3 two more times to completely purge water from
inner tank.
If you are experiencing any problems with your Brewer, please contact
Customer Service at 1.866.901.BREW (2739).
pack.
9
pack).
®