Release Notes Information - HP StorageWorks 2/140 - Director Switch Release Note

Release Notes Information

Release Notes Information
These Release Notes cover the following major topics:
4
Embedded Web Server access to modify zones is limited to first 255
page 19
SNMP trap reports incorrect FRU
Director 2/140 Maintenance Port Baud Rate may be Set
Downgrading Firmware in Director 2/140 may Cause Database
page 20
Upgrading Firmware in Director 2/64 may Time-out if Very
HSG80 Transparent Mode Not Supported with IBM
HSG80 Transparent Mode Not Recommended with Controller in SCSI-3
Mode with HP-UX Operating
ISL Disconnect Causes NOS Error with the OpenVMS Operating
page 21
Support for Speed Auto-Negotiate, page 22
Ports May Accumulate Spurious
IML is Required After Performing a Configuration
Error Can Be Caused if Port Speed is Changed Simultaneously for All Ports
of a Director 2/140, page 23
Adding a Defective ISL Connection May Cause all ISLs to Segment Between
the Two Switches or
Possible Switch Reset After Power Failure or Power Off
Erroneous Error Message When No Firmware File
A Device Cannot Send Frames to Itself After the Active Zone Set Is
Deactivated, page 24
False SBAR Failure in Director 2/64 Under Very High Fibre Channel
page 24
position, page 19
Systems, page 21
Events, page 22
Directors, page 23
zones,
Incorrectly, page 20
Event,
Busy, page 20
AIX, page 21
Systems,
Reset, page 22
Sequence, page 23
Selected, page 24
Traffic,
Director Release Notes