Color Correction Adjustment - Sanyo PLC-XF60 Owner's Manual

■ Color Correction Adjustment

Adjust Color purity according to the following procedures.
Signal to adjust
Use video or computer signal generators which can select bright
layer(Level).
About Color Correction data
Color Correction needs to be made for each lamp mode.
Each lamp mode has the correction data. The data loaded when starting up
the correction is the one for the current lamp mode. Color purity needs to
be adjusted for each layer of the brightness. It means you need to
adjust the data for each layer of the brightness.
Adjustment is made for each level of the brightness shown below.
When selecting XGA, there are 8 layers; L1(80%), L2(65%), L3(50%),
When selecting SXGA+0, there are 4 layers; L1(50%), L2(25%), L3(12.5%), L4(2%)
✼ Number of rayers and levels differ by projector.
Press "Correction layer" button in the toolbar to select the layer of the brightness
(Adjustment hierarchy). Press "Correction layer" button then the adjusted data of the
layer of the brightness is displayed on the screen.
Adjustment is made according to the following procedure.
1. Load the data to adjust from the projector
2. Set the input signal white level
3. Select the "Correction layer" in the toolbar on the edit screen to match the signal
level set in 2.
4. Confirm the area of the color shading on the projected screen.
5. Adjust the color purity.
6. Send the data to the projector.
7. Confirm the correction on the screen.
8. Repeat step 4 to 7.
9. Repeat step 2 to 8 and adjust each layer.
10. Repeat step 1 to 9 for each lamp mode.
When projecting the image from the back of the screen, select "Rear projection" in
the "Projector (P)". When projecting from ceiling mounting projector, select "Ceiling" in
"Projector (P)".
L4(40%), L5(30%), L6(20%),L7(10%),
L8(5%)
Color Correction
17