A Regulatory Compliance And Safety; Regulatory Compliance; Regulatory Compliance Identification Numbers; Regulatory Compliance Label Location - HP PCIe U320 User Manual

A Regulatory compliance and
safety

Regulatory compliance

Regulatory compliance identification numbers
For the purpose of regulatory compliance certifications and identification, your product has been
assigned a unique Regulatory Model Number. The RMN can be found on the product nameplate label,
along with all required approval markings and information. When requesting compliance information for
this product, always refer to this RMN. The Regulatory Model Number should not be confused with the
marketing name or model number of the product.

Regulatory compliance label location

The BSMI and UCCI labels are located on the non-static bag containing the adapter.
Regulatory model number
FCLSE-0644
Emissions classification
Class A

Federal Communications Commission notice

Part 15 of the Federal Communications Commission (FCC) Rules and Regulations has established Radio
Frequency (RF) emission limits to provide an interference-free radio frequency spectrum. Many electronic
devices, including computers, generate RF energy incidental to their intended function and are, therefore,
covered by these rules. These rules place computers and related peripheral devices into two classes, A
and B, depending upon their intended installation. Class A devices are those that may reasonably be
expected to be installed in a business or commercial environment. Class B devices are those that may
reasonably be expected to be installed in a residential environment (such as personal computers). The
FCC requires devices in both classes to bear a label indicating the interference potential of the device as
well as additional operating instructions for the user.
The rating label on the device shows which class (A or B) the equipment falls into. Class B devices have
an FCC logo or FCC ID on the label. Class A devices do not have an FCC logo or FCC ID on the label.
Once the class of the device is determined, refer to the following corresponding statement.

Class A equipment

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference, in which case the user is required to correct
the interference at personal expense.
41
User guide