HP P6000 Replacement Instructions page 4

3. Place the cover on the controller module rails and slide the cover
over the controller until the latch clicks into place.
Figure 8 Installing the controller cover
.
4. Move the small form-factor pluggable (SFP) modules, installed in
the unused FC host ports, from the controller being replaced to the
new controller (if there are unused FC ports).
5. Reinstall the controller.
a. Push the controller halfway into the controller enclosure (1,
Figure 9).
b. Connect the SAS device port cables to the controller device
ports.
NOTE:
Inserting a controller without connecting the device
port cables may result in soft diagnostic errors
being reported.
c. Fully insert the controller. Move the mounting latch to the left
until fully engaged and the controller is fully seated in the
enclosure (2). The controller should power up automatically.
Tighten the controller latch thumbscrew.
Figure 9 Installing a controller
.
d. Reinstall the FC host cables and any disconnected Ethernet or
console cables.
Verifying proper operation
After replacing the controller, check the following to verify the component
is operating properly:
NOTE:
Wait approximately 3 minutes for the system to check the
component status.
Verify the controller health green LED is lit (see
reseating the controller in the enclosure.
From HP P6000 Command View, navigate to the component as de-
scribed in the Verifying component failure
status. It should be
Page 4
Table
section, and check the
(Good).
1). If not, try