Backing Up The Sas Switch; Backing Up Remaining Hp P4800 G2 Solution Configurations - HP P4000 Maintenance Manual

Figure 5 Virtual Connect Manager Domain Settings

Backing up the SAS switch

The SAS switch configuration cannot be backed up using the CMC. If replacing one SAS switch,
duplicate the configuration from the other switch. If replacing both SAS switches, you will need to
restore the configuration from a backup captured using the VSM CLI. For information about backing
up and restoring the SAS configuration using the CLI, see the HP Virtual SAS Manager User Guide.
IMPORTANT:
cabling between the SAS switches and the disk enclosures. See
(page 32) for the recommended cabling.

Backing up remaining HP P4800 G2 solution configurations

The following methods may be used to back up the remaining HP P4800 G2 solution configurations:
Use your own system backup utility to back up data.
Back up the configuration to an FTP server.
HP recommends that you not change the SAS zoning on the SAS switches or the
"HP P4800 G2 solution cabling"
Backing up the SAS switch 13