Run Server Diagnostics - HP P4000 Maintenance Manual

NOTE:
Table 3 (page
Table 2 Minimum requirements, overview category
Item
CPU
Type and number of drives
Memory
NIC
9. From the Categories list, select Storage.
10. Verify that the specified item meets the minimum requirements listed in
Table 3 Minimum requirements, storage category
Item
Array Controller in Slot 0: HP Smart Array P410i
controller
Array Controller in Slot 2: HP Smart Array P700m
controller

Run server diagnostics

1. On the HP Insight Diagnostics Test tab, select Quick Test and specify the number of loops.
2. Press the Begin Testing button.
The Survey Tab displays the data from the tests.
Wait for the tests to finish. This may take several minutes.
3. When the tests have completed, select the Log tab and check the failure log to see if the Quick
Test reports any failures.
4. If the Quick Test reports any errors, fix all errors before continuing.
If you need more information about an error, run a Complete Test on any component that
reported a failure.
If you want to run only specific tests, use the Custom Test option.
For assistance with the Complete or Custom Test options, see the HP SmartStart CD x64 or
contact HP technical support.
5. Press the Exit Diagnostics button.
If any items do not meet the requirements listed in
17), do not continue with this procedure.
Table 2 (page 17)
Minimum requirement
CPU on the storage blade: Intel Xeon Processor @ 2.40
Ghz
37 hard drives, which include the following:
Slot 2: 35 drives on the HP Smart Array P700m
controller
Slot 0: 2 drives on the HP Smart Array P410i
controller
24 GB
For the HP P4460sb G2 storage blade, the Network
Controller is Emulex OneConnect 10Gb NIC:
v3.102.453.0 or later.
Minimum requirement
Model: HP P410i
Firmware: 3.52 or later
Installed Memory: 0 Mbytes
BIOS boot device order: 1
Model: HP P700m
Firmware: 7.22 or later
Installed Memory: 512 Mbytes
Battery1: OK
BIOS boot device order: 2
Performing field system recovery of the HP P4800 G2 solution
and
Table 3 (page 17).
17