2.
To verify that the host has been created, issue the showhost command.
# showhost
Id Name
...
2 hpux-host
Configuring the HP 3PAR Storage System Running InForm OS 2.2.x
This section describes how to configure the HP 3PAR Storage System running InForm OS 2.2.x.
REQUIRED
The following setup must be completed before connecting the HP 3PAR Storage System port to a
device.
Configuring Ports for a Direct Connection
To configure the HP 3PAR Storage System ports for a direct connection, complete the following
steps.
1.
Set each HP 3PAR Storage System port to port personality 5 by issuing controlport
persona 5 <X:X:X>, where <X:X:X> is the port location, expressed as node:slot:port.
# controlport persona 5 1:2:1
2.
Verify that each port has the appropriate personality defined:
# showport -par
N:S:P ConnType CfgRate MaxRate
IntCoal
...
1:2:1
enabled
...
NOTE:
WWN does not show up.
Configuring Ports for a Fabric Connection
To configure the HP 3PAR Storage System ports for a fabric connection, complete the following
steps.
1.
Set each storage server port that will connect to a fabric to port persona 8 by issuing
controlport persona 8 <X:X:X>, where <X:X:X> is the port location, expressed as
node:slot:port.
8
Configuring the HP 3PAR Storage System for Fibre Channel
Persona
HPUX-legacy 1122334455667788 ---
loop
auto
2Gbps disable disabled
When deploying your storage server in a direct connection, the HP Tachyon HBA
-WWN/iSCSI_Name- Port
1122334455667799 ---
Class2
VCN ------------Persona-------------
(5) aglt, g_hba, hp, 0, DC