Table of Contents
Advertisement
LV Name
LV Status
LV Size (Mbytes)
Current LE
Allocated PE
Used PV
--- Physical volumes --
PV Name
PV Name
PV Status
Total PE
Free PE
Autoswitch
NOTE:
the PVLinks feature to manage device paths.
7.
If the VERITAS Volume Manager's DMP driver is to be used, make the newly-registered VLUNs
visible to the DMP layer using the following command which causes VxVM to rebuild its view
of the device nodes:
# vxdctl enable
NOTE:
the same devices.
NOTE:
HP-UX's ioscan and insf commands before executing any LVM and VxVM commands for the
new devices.
NOTE:
Replace fcd to td if using the A6795 or A5158 HBA in the below examples. The below
example is for the A6826A HBA.
8.
The fcmsutil utility can be used to display important information about each HBA port using
the port's /dev/fcd<instance> device node. The fcd instance number is shown in the
output of the ioscan -fun command.
# ioscan -fun
Class
===========================================================================
fc
0 0/0/8/1/0
2Gb Dual Port PCI/PCI-X Fibre Channel Adapter (FC Port 1)
NOTE:
connect. The below example is for Fabric.
# fcmsutil /dev/fcd0 (for Fabric connect)
MHz
34
Allocating Storage for Access by the HP-UX Host
/dev/testdg/testvol1
available/syncd
10000
2500
2500
1
/dev/dsk/c120d1
/dev/dsk/c14t0d1 Alternate Link
available
2559
0
On
Refer to HP documentation at
LVM and VxVM may coexist on the same system but should not be used to manage
Remember to create raw and block device paths for the exported VLUNs using
The driver for AB379A, A6826A is fcd and driver for A6795A, A5158A is td.
I H/W Path
Driver
fcd
Topology will be PRIVATE_LOOP for Direct connect and PTTOPT_FABRIC for Fabric
http://docs.hp.com
S/W State
H/W Type
CLAIMED
INTERFACE
PCI Sub-system Vendor ID is = 0x00103c
for complete information on using
Description
HP A6826-60001
Vendor ID is = 0x001077
Device ID is = 0x002312
PCI Sub-system ID is = 0x0012ba
PCI Mode
ISP Code version
= PCI-X 133
= 3.3.153/
Advertisement
Table of Contents
