Installation Instructions; Important Notes - HP MPX200 Release Note

You must sign up for an HP Passport to access this website.
Fixes
The following fixes have been implemented in firmware version 3.3.0.3:
iSCSI fixes:
Lunmask failure in that if target A was accessible on blade 1 only and target B was
◦
accessible on blade 2 only, both blades showed targets A and B were visible to them
and available for lunmasking.
nl
Fix: Targets were removed that were not accessible to the blade. A CLI 'show targets'
command confirms the right targets are visible to the blade.
Router reboot: In certain non standard configuration conditions, a router reboot might
◦
occur.
nl
Fix: Router reboot condition has been fixed.
Data Migration fix: MSA (active-active) related DM fix
Prerequisites
HP P6000 Command View: The MPX200 requires HP P6300/P6500 requires HP P6000 Command
View 9.4 or later.FCoE requires P6000 Command View 9.3 or later.

Installation instructions

For information about installing the MPX200 Multifunction Router, see the HP MPX200 Multifunction
Router EVA iSCSI Quick Start Instructions for Microsoft Windows, the HP Multifunction Router FCIP
Quick Start Instructions, and the HP MPX200 Multifunction Router User Guide, available on the
HP Manuals website:
http://www.hp.com/support/manuals
Under Storage, click Storage Networking, and then under Routers/Gateways/Multiplexers, select
HP MPX200 Multifunction Router.

Important notes

FCoE notes
Command View EVA auto-presented offline targets
In a configuration with multiple MPX200 Multifunction Routers (different chassis enclosures) within
the same FC zone, auto-presented offline targets for the FCoE ports will display under the P6000
Command View iSCSI controller FC Ports tab.
LUN 0 presentation for MPX200 FCoE/iSCSI target
When managing an P6000/EVA using an FCoE/iSCSI CNA-based server with MPX200
FCoE/iSCSI target connectivity, un-presenting the last FCoE/iSCSI LUN from the MPX200
FCoE/iSCSI Controller may cause Command View to lose communication with the array. To resolve
this problem, use the MPX200 CLI to present LUN 0 from each EVA Fibre Channel target WWN
to each of the MPX200 FCoE/iSCSI ports, and to each of the management server's FCoE/iSCSI
CNA ports. If you use a dual-blade MPX200 chassis, you must execute this presentation process
for both MPX200 Blades.
Fixes 5