Screw Holes; Pre-Installation Precautions - ASROCK ZH77 Pro3 Quick Installation Manual

Quick installation guide

Hide thumbs Also See for ZH77 Pro3:

Table of Contents

2. Installation

This is an ATX form factor (12.0" x 7.6", 30.5 x 19.3 cm) motherboard. Before you

install the motherboard, study the conﬁ guration of your chassis to ensure that the

motherboard ﬁ ts into it.

Make sure to unplug the power cord before installing or removing the

motherboard. Failure to do so may cause physical injuries to you and

damages to motherboard components.

2.1 Screw Holes

Place screws into the holes indicated by circles to secure the motherboard to the

chassis.

Do not over-tighten the screws! Doing so may damage the motherboard.

Take note of the following precautions before you install motherboard components

or change any motherboard settings.

Unplug the power cord from the wall socket before touching any

components.

To avoid damaging the motherboard's components due to static

electricity, NEVER place your motherboard directly on the carpet

or the like. Also remember to use a grounded wrist strap or touch a

safety grounded object before you handle the components.

Hold components by the edges and do not touch the ICs.

Whenever you uninstall any component, place it on a grounded anti-

static pad or in the bag that comes with the component.

When placing screws into the screw holes to secure the mother-

board to the chassis, please do not over-tighten the screws! Doing

so may damage the motherboard.

Before you install or remove any component, ensure that the power is

switched off or the power cord is detached from the power supply. Failure to do

so may cause severe damage to the motherboard, peripherals, and/or

components.

ASRock ZH77 Pro3 Motherboard

Table of Contents