Start Auto Tuning - Asus P5P41T USB3 User Manual

The following table shows the DRAM Frequency options that appear when the FSB value is
1333, 1066, and 800.
FSB
Auto
1333 v
1066 v
800 v
Selecting a very high DRAM frequency may cause the system to become unstable! If this
happens, revert to the default setting.
Memory Voltage [Auto]
Allows you to adjust Memory Over voltage and each step is 10mV.
NB Voltage [Auto]
Allows you to set the Northbridge voltage. The values range from 1.12500V to 1.51875V with
a 0.00625V increment. Key in the value directly or use +/- to adjust the voltage.
Configuration options: [Auto]
VTT Voltage [Auto]
Allows you to set the VTT voltage. The values range from 1.20000V to 1.59375V with a
0.00625V increment. Key in the value directly or use +/- to adjust the voltage.
Configuration options: [Auto]
CPU Over Voltage [Auto]
Allows you to set the CPU over voltage. The values range from 0.0100V to 0.6300V with a
0.0100V increment. Key in the value directly or use +/- to adjust the voltage.
Configuration options: [Auto]
SB 1.5V Voltage [1.5V]
Allows you to select the South Bridge voltage. Configuration options: [1.5V] [1.6V]
Auto PSI [Enabled]
Allows you to enable or disable the Auto PSI mode.
Configuration options: [Disabled] [Enabled]

Start auto tuning

Press [Enter] to start auto tuning. It takes around five minutes and the system will reboot for
several times. After auto tuning, C-State is disabled.
ASUS P5P41T/USB3
800MHz 960MHz
v
v
v
DRAM Frequency
1000MHz 1067MHz
v
v
1100MHz 1333MHz
v
2-11