Table of Contents
Advertisement
8.
CPU and Chassis Fan connectors
(4-pin CPU_FAN, 3-pin CHA_FAN)
The fan connectors support cooling fans of 350 mA ~ 2000 mA (24 W
max.) or a total of 1 A ~ 3.48 A (41.76 W max.) at +12V. Connect the
fan cables to the fan connectors on the motherboard, making sure that
the black wire of each cable matches the ground pin of the connector.
DO NOT forget to connect the fan cables to the fan connectors. Insufficient
air flow inside the system may damage the motherboard components.
These are not jumpers! DO NOT place jumper caps on the fan connectors!
P5L 1394 Fan Connectors
Only the CPU_FAN connector supports the ASUS Q-Fan feature.
9.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch cable
to this connector. The chassis intrusion sensor or switch sends a high-
level signal to this connector when a chassis component is removed or
replaced. The signal is then generated as a chassis intrusion event.
By default, the pins labeled "Chassis Signal" and "GND" are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
P5L 1394 Intrusion Connector
2-28
CPU_FAN
R
CHA_FAN
Rotation
CHASSIS
R
GND
CPU FAN PWR
CPU FAN IN
CPU FAN PWM
+12V
GND
(Default)
Chapter 2: Hardware information
Hide quick links:
Advertisement
Table of Contents
