Perform The Settings Relating To The Motion Detection - Panasonic WV-CW504S Operating Instructions Manual

Perform the settings relating to the motion detection

Perform the settings relating to the motion detection as follows. It is possible to detect only objects that moves to the direction speci-
fied in advance or objects that keeps on moving for a certain duration. Up to 4 motions can be simultaneously detected.
Follow the procedure below.
"CAMERA SETUP" screen
**CAMERA SETUP**
SCENE1
ALC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
BW MODE AUTO1
i-VMD
RET TOP END
Step 1
Move the cursor to "i-VMD" and press the setting button.
→ The "i-VMD SETUP" screen appears.
Step 2
Move the cursor to "MOTION DET" and press the setting button.
→ The "MOTION DET" screen appears.
Step 3
The setting of the motion detection mode is performed. This unit has 3 types of motion deteciton modes.
Detect motion of objects
Move the cursor to "MOTION" and select from the following.
ON: Provides an alarm signal when motion is detected.
OFF (default): Does not detect motion.
Detect objects that move continuously within a specified period
Move the cursor to "LOITERING" and select the duration from the following:
When a continuously moving object is detected within a specified period, an alarm signal is issued.
OFF (default)/ON (5 s)/ON (10 s)/ON (20 s)/ON (30 s)/ON (40 s)/ON (50 s)/ON (1 min)
Detect objects that move into the specified direction
Move the cursor to "DIRECTION" and select the direction from the following:
An alarm signal will be sent out when an object moves to the specified direction.
OFF (default)/ON ( c )/ON ( )/ON ( a )/ON ( )/ON ( d )/ON ( )/ON ( [ )/ON ( )
Step 4
Move the cursor to "AREA" and select an area for which the motion detection is to be set.
All the alarm actions selected in step 3 will be applied to this area.
ALL (default): All areas will be set as the detection area.
SETUP: When the setting button is pressed after selecting "SETUP", up to 2 areas can be set as the detection area. Refer to page
18 for how to configure the settings.
Step 5
Move the cursor to "SENSITIVITY" and press the setting button.
→ The "SENSITIVITY" screen appears.
16
"i-VMD SETUP" screen
**i-VMD SETUP**(1)
MOTION DET
OBJECT DET OFF
SCENE CHANGE OFF
INDICATOR OFF
ALARM CONT
RET TOP END
"MOTION DET" screen
**MOTION DET**(1)
MOTION OFF
LOITERING OFF
DIRECTION OFF
AREA ALL
SENSITIVITY
RET TOP END
"SENSITIVITY" screen
**SENSITIVITY**(1)
SENSITIVITY LOW
MIN SIZE OFF
RET TOP END