Axis P1346 Installation Manual page 15

DETAILS OF THE ITEMS ABOVE:
1. Configuration Area of Live View: This is an active live view window of the
camera you connect to. The Red box designates where on the screen you want
the plate to be detected. It should be 200 pixels across within the image. This
setting has a threshold of 10% either way for optimal reads.
2. LPR Results: This contains two pieces of information. The Larger Font character
set is the image that the segmentation engine in LPR has identified as a possible
plate. The Small Font Character set is the OCR result output after the engine
has examined the possible plate and is the text that will be stored.
3. Reference Plate Zoom: This window allows the user to see more closely what
the LPR engine sees and fine tune the camera settings to maximize the read rate
of the system.
4. IP Address: This would be the IP address of the LPR designated camera you
want to connect to
5. User: User for the camera most will be root.
6. Password: Password for camera user login.
7. FPS: Frames per second – 5FPS is ideal. It may be greater with higher traffic
areas or be less at cameras viewing stop signs on busy roads.
8. Compression: Per the discovery session in Norfolk, we will set this to 1.
9. or
disconnect. Note that you must do this if making changes to the FOV settings in
order for it to be pushed to the camera for detection.
10. or
detected image and plate parameters configured in the Configuration Area of
Live View.
11.
that will be hosting the LPR piece. Due to the nature of the security involved, you
must do this from the RLS itself, do not run this on a laptop/workstation.
12. : This will allow you save all settings in a SQL Table on the RLS to
the designated LPR camera. Due to the nature of the security involved, you
must do this from the RLS itself.
: This will allow you Connect to above camera or
: This will start or stop the OCR engine from running on the
: This allows you to connect to LPR designated cameras on RLS
LPR Setup and Field Installation Guide
ipConfigure ESM 5.1
15