Oki MPS711c User Manual page 19

4. Fine tune the rear stopper (a) and paper guides (b) to the
size of paper being used.
MPS711c ONLY
IMPORTANT: Set paper size dial (c) to the size of
paper being used (A4 in the above example).
To prevent paper jams:
• Do not leave space between the paper and the guides and
rear stopper.
• Do not overfill the paper tray. Capacity depends on the
type of paper stock.
• Do not load damaged paper.
• Do not load paper of different sizes or types at the same
time.
• Close the paper tray gently.
• Do not pull the paper tray out during printing (except as
described below for the 2nd tray).
NOTES:
• If you have two trays and you are printing from the 1st
(upper) tray, you can pull out the 2nd (lower) tray
during printing to reload it. However, if you are
printing from the 2nd (lower) tray, do not pull out the
1st (upper) tray. This will cause a paper jam.
• For face down printing, make sure the face up (rear)
stacker (a) is closed (the paper exits from the top of
the printer). Stacking capacity is approximately 250
sheets for the MPS610c and 350 sheets for the
MPS711c, depending on paper weight.
19
CAUTION!
– MPS610c/MPS711c User's Guide