Synology RS812RP Quick Installation Manual page 9

3 Turn the circuit board over.
4 Insert the new memory module in the slot:
a Align the notch on the gold edge of the module with the notch in the lower memory slot.
b Tilt the card and push the memory into the slot. Make sure the module is pushed in all the way.
c Use two fingers with firm, even pressure to push down on the memory module. You should hear a click
when the memory is inserted correctly.
Important: Hold the memory module by its edges, and do not touch the gold connectors.
5 Turn the circuit board back to its original position.
6 Return the board into the RackStation:
a Identify the rail within the RackStation.
b Place the circuit board within the rail and push the board all the way in.
c Tighten the 2 knobs you unscrewed in step 2.
Make Sure RackStation Recognizes the New Memory Capacity
After installing the memory module on RackStation, it's recommended that you check whether the server
recognizes the new memory.
9 Chapter 2: Hardware Setup