Troubleshooting - Teac SR-100i Owner's Manual

If you a have problem with your system, read this page and
try to solve the problem yourself before calling your dealer
or a TEAC service Center.
General
No power
e Check the connection to the AC power supply. Check
whether or not the AC source is a switched socket. If it
is, confirm that the switch is turned on.
e Confirm that there is power to the AC wall socket by
plugging another item such as a lamp or fan into it.
No sound from the speakers.
e Select the source by pressing the FUNCTION button.
e Adjust the volume.
e If "MUTE" blinks, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar device. Relocate
it away from the interfering device or turn it off.
The remote control does not work.
e Press the Standby/On (
e If the battery is exhausted, replace it with a new one.
e Use the remote control unit within the operation
range (5 m) and point it at the remote sensor on the
front panel.
e Remove obstacles between the remote control unit
and the main unit.
e If a bright light is near the unit, turn it off.
Power cannot be turned off (put in standby) when
using an iPod touch/iPhone as the sound source.
e When using an iPod touch/iPhone with this unit, if you
use any application other than the iPod application,
the SR-100i power might turn on again soon after it
is turned off (put in standby). Since the unit cannot
turn the iPod touch/iPhone power off when such an
application is running, you must quit the application
before turning SR-100i off (putting it in standby).
32

Troubleshooting

) button to turn the unit on.
iPod Player
Cannot connect the iPod.
e Remove dust or obstacles from the dock connector of
SR-100i and the iPod, then connect the iPod again.
Cannot operate the iPod.
e Release the iPod HOLD switch.
Cannot play.
e Remove the iPod from the dock, wait a few seconds,
then connect it again.
e A software update might solve the problem. Visit the
Apple website and download the latest iPod software.
FM Tuner
Cannot listen to any station, or the signal is too
weak.
e Tune in to a station properly.
e Rotate the FM antenna until you receive the station
clearly.
CD Player
Cannot play.
e Load a disc with the label side facing you.
e If the disc is dirty, clean the surface of the disc.
e A blank disc may be loaded. Load a prerecorded disc.
e Depending on the disc, etc. it may not be possible to
play back a CD-R/RW disc. Try again with another disc.
e You cannot play back unfinalized CD-R/RW discs.
Finalize such a disc using a CD recorder and try again.