Dell S320 User Manual page 68

Q S
UICK HUTDOWN
the Power button. This function allows the projector to quickly power off
with an accelerated fan speed. Slightly higher acoustic noise is expected
during quick power off.
NOTE:
allow the internal temperature to stabilize. The projector will take a
longer time to turn on if you try to power on immediately. Its cooling fan
will run at full speed for about 30 seconds to stabilize the internal
temperature.
P S
OWER AVING
after 120 minutes of no activity. A warning message appears on screen
showing a 60 seconds countdown before switching to power saving mode.
Press any button during the countdown period to stop the power-saving
mode.
You can also set a different delay period to enter power saving mode. The
delay period is the time you want the projector to wait without an input
signal.
If an input signal is not detected during the delay period, the projector
turns off. To turn on the projector press the Power button.
D S
URING TANDBY
on/off while the projector is standby status (default is Wireless Off).
L M —Allows you to select the Normal or ECO or Dynamic mode.
AMP ODE
Normal mode operates at full power level. ECO mode operates at a lower
power level which may provide longer lamp life, quieter operation, and
dimmer luminance output on the screen.
D —Select and press
YNAMIC
L H R
AMP OUR
lamp hour.
68 Using Your Projector
—Select On to turn off the projector with a single press of
Before you turn on the projector again, wait for 60 seconds to
—By default, the projector is set to enter power saving mode
—Select Wireless On or Off set the Wireless/LAN model
—Press and select the Confirm option to reset the
ESET
to activate image care feature.