Hitachi CP-WX3014WN Operating Manual page 53

SETUP menu
44
Using ▲/▼ buttons switches the standby mode setting between
NORMAL and SAVING.
NORMAL SAVING
When SAVING is selected, the power consumption in the standby
mode is lowered with some functional restriction as below:
• When SAVING is selected, the RS-232C communication control
except to turn the projector on and the network function are disabled
while the projector is in the standby mode. If the COMMUNICATION
TYPE in the COMMUNICATION menu is set to NETWORK
BRIDGE, all of the RS-232C commands are disabled (
• When SAVING is selected, STANDBY setting of AUDIO SOURCE
45) is invalid, and no signal is output from
(
the standby mode.
• When SAVING is selected, STANDBY setting of MONITOR OUT
is invalid, and no signal is output from
standby mode.
While the image signal from the input port chosen in step (1) is
projected, the image signal from the input port selected in step (2) is
output to
(1) Choose a picture input port using ▲/▼ buttons.
Choose STANDBY to select the picture
output in the standby mode.
(2) Select one of the
using ◄/► buttons.
Select OFF to disable the
port for the input port or standby mode
chosen in the step (1).
• You cannot select
in step (2) and vice versa.
port.
ports
in step (1) and
59).
port in
port in the