Sony KDL-46HX820 Manual page 5

8 Adjust the angle of the Mounting Bracket.
Use the supplied hexagon wrench.
When installing the Display parallel to the wall (0 degrees), adjustment of the Mounting Bracket angle
(procedures  and  below) is not necessary.
 Remove the two angle adjusting screws from the Mounting Bracket.
 Secure the screws to the corresponding holes for the desired angle (", " "5, " "0, " "5" or
"0").


✍
• Be sure that both the left and right sides are set to the same angle, and secure the screws to the
corresponding angle holes (two screws for each side, left and right).
• Make sure that the two arms of the Mounting Bracket are screwed in securely.
CAUTION
Be careful not to pinch your fingers when adjusting the angle of the Mounting Bracket.
9 Install the TV on the wall.
Refer to the Instructions for SU-WL700.
Make sure that you carry out this task with at least two or three people.
Do not attempt to lift the TV by yourself.
For holding and carrying the TV, refer to your TV's instructions.
✍
• When you put the TV back on the stand, reverse the above steps.
• Remove the screws or install the Mounting Bracket on a stable and level surface.
• Available TV models vary depending on the country/region.
• The availability of this Wall-Mount Bracket (SU-WL700) varies depending on the country/region.
Additional Information for Using Sony Wall-Mount Bracket (SU-WL700)
Hexagon
wrench
− 5 −