HP Xw9400 - Workstation - 16 GB RAM Installation Manual page 5

2. Attach the front fan to the card guide.
a. Place the fan in the card guide with the fan label facing into the card guide and the fan protector
screen facing outward.
b. Place the fan wire through the slot in the card guide.
c. Snap the fan into place in the card guide.
Figure 3
3. Install the front fan/card guide assembly.
a. Lower the front fan/card guide assembly into the chassis
b. Rotate the assembly back
c. Connect the front fan wire connector to the front fan connector on the system board
NOTE:
workstation access panel.
Figure 4
ENWW
Attaching the front fan to the card guide
2
To identify the front fan connector on the system board, see the service label on the
Installing the front fan/card guide assembly in the chassis
Step 2—Installing the front PCI fan in the HP xw8600 Workstation
, and then snap it into place.
.
.
5