HP Xw6600 - Workstation - 2 GB RAM Installation Manual page 4

Dual-port network interface card (nic)
Hide thumbs Also See for Xw6600 - Workstation - 2 GB RAM:
Table of Contents

Advertisement

Step 2—Installing the dual-port NIC
Introduction
This section describes how to install the NIC in your workstation.
Procedure: Installing the NIC
Table 2
Installing the NIC
Step
1
2
3
4
4
Dual-port NIC installation
Action
Release the PCI retainer levers by pressing them down, then out (1), as shown next.
Remove the applicable PCI Express slot cover (2).
Verify that the keyed components of the card align with the socket.
Install the dual-port NIC by pressing it securely into the slot (3).
When the card is installed, close the PCI levers (4).
ENWW

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Xw6600 - Workstation - 2 GB RAM and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Xw8600 - workstation

Table of Contents