Removing And Replacing The Side Access Panel And Metal Side Cover; Removing The Side Access Panel And Metal Side Cover - HP vc4820T - Thin Client Hardware Reference Manual

Hp vc4820t/vc4825t thin clients hardware reference guide

Hide thumbs Also See for vc4820T - Thin Client:

Table of Contents

Removing and Replacing the Side Access Panel and Metal

Side Cover

WARNING!

power cord is disconnected from the electrical outlet.

To remove the access panel:

Remove the secure compartment cover (1). For more information, see

Compartment Cover on page

Lay the unit flat on a stable surface with the right side up and the left side down.

Slide the access panel about 3 mm (1/8 inch) toward the top of the unit (2), and then lift the access

panel up and off the unit (3).

Figure 2-3

To remove the metal side cover:

NOTE:

You must remove the metal side cover to access internal components such as the battery or

the memory.

Remove the four screws that secure the metal side cover to the chassis (1).

Chapter 2 Hardware Changes

Before removing the side access panel, ensure that the thin client is turned off and the

12.

Removing the side access panel

Removing the Secure USB

ENWW

Table of Contents

Vc4825t