Closing The Hp Touchsmart Pc - HP TouchSmart IQ520 - Desktop PC Manual

Closing the HP TouchSmart PC

To avoid injury and equipment damage, always complete the following steps in order, after closing the
HP TouchSmart PC:
1 If you removed it, replace the computer stand. Align the four screw holes of the stand over the four
holes on the back of the computer, and then replace the four screws that secure the stand to the
computer.
2 Replace the memory cover. Align the memory cover over the two legs of the computer stand and the
screw hole and slide toward the stand and into place (A). Push down on both sides of the bottom edge
of the memory cover to snap it into place (B). Push in the middle of the bottom edge to make sure the
entire cover is pushed all the way down.
A
B
Upgrading and Servicing Guide
23