Hp Thinstate Capture - HP T5720 - Compaq Thin Client Quick Reference Manual

HP ThinState Capture

The HP ThinState Capture tool is a very simple wizard-based tool that you can use to capture an HP
thin client XP Embedded image, which you can then deploy to another HP thin client of identical model
and hardware.
What do you need to have?
●
An HP thin client XP embedded unit that contains the latest HP provided image
●
An HP-approved USB flash drive (Disk-On-Key). Consult the t5720 quick specs for the latest
approved USB flash drives.
WARNING!
Flash, and finally to Network boot. If the default Boot order settings have been changed, it is critical
before using the HP ThinState Capture tool that you first set the First Boot Device in the Advanced Bias
Features section of the F10 System Bias to USB.
NOTE: The HP ThinState Capture tool is not a standalone tool and can only be accessed by the
administrator from within the thin client image.
Save all data on the USB flash drive prior to performing this procedure.
1. Once you launch the HP ThinState Capture tool from within the Control Panel, you are presented
with the following screen.
34 Chapter 4 Control Panel extended selections
By default, the First Boot Device in the F10 System BIOS is first set to USB, then ATA
ENWW