Remote Control Unit Operations; Operating Denon Audio Components; Presetting; Operating Preset Components - Denon DHT-788BA Owner's Manual

Remote Control Unit Operations

[Front]
[MODE
SELECTOR 1]
[Rear]
[ZONE2 OFF]
[NUMBER]
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.
Operating DENON Audio
Components
1
[MODE SELECTOR 1]
Set
2
[MODE SELECTOR 2]
Set
component to be operated (CD, iPod/NETWORK or
TAPE/CD-R/MD).
3
Operate the audio component.
[MODE
SELECTOR 2]
b For details, refer to the component's operating instructions.
b While this remote control is compatible with a wide range of
infrared controlled components, it may be the case that some
component models cannot be operated with this remote control.

Presetting

• DENON and other makes of components can be operated by
setting the preset memory.
[MAIN ON]
• This remote control unit can be used to operate components
of other manufacturers without using the learning function by
registering the manufacturer of the component as shown in the
list of preset codes (vEnd of this manual).
• Operation is not possible for some models.
1
[MODE SELECTOR 1]
Set
b Set to the AUDIO side for the CD or TAPE/CD-R/MD position,
and to the VIDEO side for the DVD/VDP , SAT/CABLE, VCR or TV
position.
2
[MODE SELECTOR 2]
Set
registered.
3
[ZONE2 OFF]
Press
The indicator starts flashing.
4
Referring to the included list of preset codes, press
[NUMBER]
for the manufacturer of the component whose signals
you want to store in the memory.
5
To store the codes of another component in the
memory, repeat steps 1 to 4.
to "AUDIO".
to the position for the
to "AUDIO" or "VIDEO".
to the component to be
[MAIN ON]
and at the same time.
to input the preset code (a 3-digit number)
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• The preset memory can be set for one component only among the
following: TAPE/CD-R/MD, DVD/VDP and SAT/CABLE.

Operating Preset Components

1
[MODE SELECTOR 1]
Set to "AUDIO" or "VIDEO".
b Set to the AUDIO side for the CD or TAPE/CD-R/MD position,
and to the VIDEO side for the DVD/VDP , SAT/CABLE, VCR or TV
position.
2
[MODE SELECTOR 2]
Set to the component you want
to operate.
3
Operate the component.
b For details, refer to the component's operating instructions.
b Some models cannot be operated with this remote control unit.
ENGLISH