Table of Contents
Advertisement
Removing the Front Bezel
1.
Remove/disengage any security devices that prohibit opening the computer.
2.
Remove all removable media, such as compact discs or USB flash drives, from the computer.
3.
Turn off the computer properly through the operating system, then turn off any external devices.
4.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
5.
Remove the computer access panel.
6.
Lift up the three tabs on the side of the bezel (1), then rotate the bezel off the chassis (2).
Figure 2-4
Removing Bezel Blanks
On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch drive bays that need to
be removed before installing a drive. To remove a bezel blank:
1.
Remove the access panel and front bezel.
14
Chapter 2 Microtower (MT) Hardware Upgrades
Regardless of the power-on state, voltage is always present on the system board
Removing the Front Bezel
Advertisement
Table of Contents
