HP c3750 - Workstation Troubleshooting Manual page 4

Troubleshooting SCR+DMI for HP-UX
2. Double-click on the icon with the system name.
3. Double-click on the
4. Check SCR on the server.
Table 1-1 Status Values
Status
Completed
Executing
Scheduled
Warning or
Error
6
A task dialog labeled "MIF Browser" will be launched. An icon with the system name
should be in the dialog.
The contents of the dialog should be replaced with three icons labeled:
•
DMI 2.0 Service Provider
•
HP-UX Standard Groups Definition
•
HP-UX Installed Software Definition
HP-UX Standard Groups Definition
displayed with labels including:
•
General Information
•
Operating System
•
Host System
Run /opt/scr/bin/scrstatus
The output will list a time, a node name, the status on that node and details. Possible
results include the following:
Detail
-
-
-
Tmout
AcErr
What this means
SCR worked correctly on this node at this time
SCR is currently collecting data on this node.
SCR is set to collect data from this node at the
time listed under the "Time" column.
Timeout. Possible problems include:
- DCE/RPC problem
- Network problem
You can increase the timeout value with the
/opt/scr/bin/scrconfig command. HP
recommends a value of 10 minutes, and even
more time may be required if your network
slows down.
Access Error. This means SCR could not collect
data from the client. Potential problems are:
- The DMI daemons are not running (either on
the server or the client),
- The server IP address is not in the
/var/dmi/dmiMachines file on the client,
- The network is not working.
icon. Multiple icons should be
Chapter 1