HP Presario SG3000 - Desktop PC Manual page 14

10
Upgrading and Servicing Guide
4 Make sure the jumper on the new optical drive or new Parallel ATA hard disk drive is
in the CS (Cable Select) position. Your drive may vary from the illustration. The Serial
ATA hard disk drive does not use Cable Select.
CS SL MA
Cable Select jumper
5 Release the drive bay by pulling the latch out away from the chassis and then sliding
the drive part way into the front of the chassis. (The latch drive brackets secure the
drives in their respective positions in the chassis.)
6 Connect the power and data cables from the back of the drive you want to add.
Reconnect the sound cable, if present.
WARNING: For a second Parallel ATA drive, make sure to connect the data
cable labeled Master to the primary hard disk drive, and the data cable
labeled Slave to the secondary hard disk drive. If the data cable is not
connected correctly, the PC is unable to locate the hard disk drive and data
may be lost.
1