Replacing A Memory Module - Lenovo J100 Hardware Maintenance Manual

4. Slide the drive bay assembly forward until it stops. Disconnect the power
5. Reverse this procedure to replace the drive bay assembly and bezel.

Replacing a memory module

1. Remove the cover. See "Removing the cover" on page 114.
2. Remove the drive bay assembly. See "Removing and replacing the drive bay
3. Locate the memory connectors. See "Identifying parts on the system board" on
4. Open the retaining clips and remove the failing memory module.
120
Lenovo 3000 J Series
supply and signal cables from the drives. Pivot the rear of the drive bay
assembly upward to remove it completely from the computer.
Note: To allow easier access to the cables, lift the fan plenum off the heat sink.
See "Locations" on page 115.
assembly" on page 119.
page 116.