Lenovo Ispirati 2001 User Manual page 41

4-10
IDE Primary Master
PIO
IDE Primary Slave
PIO
IDE Secondary
Master PIO
IDE Secondary
Slave PIO
IDE Primary Master
UDMA
IDE Primary Slave
UDMA
IDE Secondary
Master UDMA
IDE Secondary
Slave UDMA
USB Controller
USB Keyboard
Support
Init Display First
AC97 Audio
AC97 Modem
IDE HDD Block
Mode
Onboard FDD
Controller
Onboard Serial
Port 1
Onboard Parallel
Port
Onboard Parallel
Mode
EPP Mode Select
ECP Mode Use
DMA
Item Options
Auto
Mode0
Mode1
Mode2
Mode3
Mode4
Auto
Disable
Enabled
Disabled
Enabled
Disabled
PCI Slot
Onboard
Auto
Disabled
Enabled
Disabled
Disabled
Enabled
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Auto
Disabled
3BC/IRQ7
278/IRQ5
378/IRQ7
Normal
EPP
ECP
ECP/EPP
EPP 1.7
EPP 1.9
1
3
Chapter 4: BIOS Setup
Description
Sets the mode of PIO and UDMA.
If 'On-Chip Primary PCI IDE' is
disabled, Primary devices (Primary
Master PIO/UDMA, Primary Slave
PIO/UDMA are disabled and
cannot be modified. If 'On-Chip
Secondary PCI IDE' is disabled,
Secondary devices (Secondary
Master PIO/UDMA, Secondary
Slave PIO/UDMA) are disabled and
cannot be modified.
Enables or disables USB drive
controller.
Enables or disables USB keyboard
if 'USB Controller' is enabled.
Determines where initial display
signals are derived from, PCI slot
or onboard VGA.
Enables or disables these features.
If IDE hard drive supports block
mode, select 'Enabled' for
automatic detection of the optimal
number of block reads/writes per
sector that the hard drive can
support.
Enables the floppy drive controller
on the motherboard.
Specifies the base I/O port address
and interrupt signal of serial port.
Sets the base I/O port address and
interrupt signal for parallel port.
Selects mode of parallel port if
'Onboard Parallel Port' is not
disabled.
'Normal' ' normal parallel mode
'EPP' ' Enhanced Parallel Port
'ECP' ' Extended Capabilities
Port
Selects type of EPP parallel mode.
Selects DMA channel for ECP
parallel port mode.