Replacing The Mouse - Lenovo IdeaCentre Q200 Hardware Replacement Manual

connector
the front or rear of the computer.
4. Disconnect the failing keyboard cable from the computer and connect the new
keyboard cable to the same connector.
5. Refer to the "Completing the installation".

Replacing the mouse

Attention
Do not remove the computer cover or attempt any repair before reading the
"Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at http://www.lenovo.com/support.
To replace the mouse:
1. Remove any media (diskettes, CDs, or tapes) from the drives, shut down your
operating system, and turn off all attached devices and the computer.
2. Unplug all power cords from electrical outlets.
3. Locate the connector for the mouse. Refer to "Locating connectors on the front
of the computer" and "Locating connectors on the rear of the computer".
Note: Your mouse might be connected to the standard mouse connector
at the rear of the computer or to a USB connector
rear of the computer.
34
Hardware Replacement Guide
31032756_HaWaii-HRG_EN.indd 34
at the rear of the computer or to a USB connector at either
at either the front or
2008.1.8 3:31:43 PM