Selecting A Single Picture And Printing It - Panasonic DMCFH3 - DIGITAL STILL CAMERA Operating Instructions Manual

Note
• This unit cannot stand upright when the AC adaptor is connected. When operating it on a flat
surface, we recommend placing it on a soft cloth.
• Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
• Turn the camera off before connecting or disconnecting the AC adaptor (optional).
• Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
• You cannot switch between the built-in memory and the card while the camera is connected to
the printer. Disconnect the USB connection cable, insert (or remove) the card and then connect
the USB connection cable to the printer again.
Press 2/1 to select the picture and then press
[MENU/SET].
• The message disappears in about 2 seconds.
Press 3 to select [PRINT START] and then press
[MENU/SET].
• Refer to "Print Settings"
before starting to print the pictures.
• Press [MENU/SET] to cancel printing halfway.
• Disconnect the USB connection cable after printing.
Connecting to other equipment

Selecting a single picture and printing it

(P114) for the items which can be set
- 112 -
PictBridge
12
100-0001 100-0001
PLEASE SELECT
THE PICTURE TO PRINT
MULTI PRINT
SELECT PRINT
SINGLE SELECT
PRINT START
PRINT WITH DATE OFF
NUM. OF PRINTS
1
PAPER SIZE
PAGE LAYOUT
CANCEL SELECT SET