HP Brio 71xx Installation Manual page 10

After you have decided if your hard disk drive will be a primary
or secondary drive, refer to
"Installing the Hard Disk Drive in Your PC" on page 6.
Configuring Without Cable Select
CAUTION HP recommends that only qualified persons should change these and
other drive settings.
Follow these procedures to disable the cable select feature if your
PC's data cable does not support cable select:
Configuring Your New Hard Disk Drive
1 Remove the cable select jumper from the hard disk drive. If
2 Configure the drive either as the master (bootable) or as the
NOTE For jumper positions refer to the HP IDE Hard Disk Drive
Technical Information which accompanies this HP IDE Hard Disk
Drive Installation Guide.
Configuring an Existing Hard Disk Drive
1 Remove the cable select jumper (marked CS) from the hard disk
2 To configure as either the primary (bootable) or secondary drive,
necessary, use tweezers or needle-nose pliers to remove a
jumper.
slave drive by selecting appropriate jumper position. Note that
only one primary and one secondary drive are allowed on the
same data cable.
drive.
install jumpers according to the type of your existing hard disk
drive.
Configuring Your Hard Disk Drive
English
English 5