Installing The Processor - Asus Rambus P3C-L User Manual

3. HARDWARE SETUP

3.6.4 Installing the Processor

NOTE: The following steps assume that you have already attached the heatsink and
installed the URM into your motherboard.
1. Make sure that the processor substrate key is aligned with the Slot 1 connector key.
Substrate Key
2. Push down firmly but gently the SECC2/SECC/SEPP into the URM until it
snaps into place.
NOTE: The processor edge fingers must be kept parallel to the connector or else
misalignment will occur.
SECC for Pentium II only: Secure the SECC in place by pushing the two SECC
locks outward so that the locks show through the retention mechanism's lock holes.
SECC2/SEPP: When engaged, the T-bars lock into the slots at the two ends of
the SECC2/SEPP heatsink.
SECC
Lock hole
3. If your URM is of type A, make sure the locks are in the locked position as shown.
34 ASUS P3C-L / P3C-S / P3C-LS User's Manual
SECC2/SEPP
Lock hole
CPU fan cable to
fan connector
Locked Position
(push upward)
Connector Key
CPU fan
cable to fan
connector