Asus P3B-1394 User Manual page 32

3. HARDWARE SETUP
9) IDE Connectors (Two 40-1pin PRIMARY/SECONDARY IDE)
These connectors support the provided IDE hard disk ribbon cable. After connect-
ing the single end to the board, connect the two plugs at the other end to your hard
disk(s). If you install two hard disks, you must configure the second drive to Slave
mode by setting its jumper accordingly. Refer to the documentation of your hard
disk for the jumper settings. BIOS now supports SCSI device or IDE CD-ROM
bootup (see HDD Sequence SCSI/IDE First and Boot Sequence in 4.4 BIOS
Features Setup). (Pin 20 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 20 plugged).
TIP: You may configure two hard disks to be both Masters with two ribbon
cables – one for the primary IDE connector and another for the secondary IDE
connector. You may install one operating system on an IDE drive and another on
a SCSI drive and select the boot disk through Boot Sequence in 4.4 BIOS Fea-
tures Setup.
P3B-1394
P3B-1394 IDE Connectors
10) Floppy Disk Drive Connector (34-1pin FLOPPY)
This connector supports the provided floppy disk drive ribbon cable. After con-
necting the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).
P3B-1394
P3B-1394 Floppy Disk Drive Connector
32
®
®
ASUS P3B-1394 User's Manual
NOTE: Orient the red markings (usually zigzag)
on the IDE ribbon cable to pin 1
Secondary IDE Connector
Pin 1
Primary IDE Connector
Floppy Disk Drive Connector
Pin 1