Serial Ata3 (Sata3) Hard Disks Installation; Hot Plug And Hot Swap Functions For Sata3 Hdds - ASROCK 990FX Extreme9 User Manual

2.13 Serial ATA3 (SATA3) Hard Disks Installation

This motherboard adopts AMD SB950 chipset that supports Serial ATA3 (SATA3)
hard disks and RAID (RAID 0, RAID 1, RAID 0+1, JBOD and RAID 5) functions.
It also adopts ASMedia ASM1061 chipset that supports Serial ATA3 (SATA3) hard
disks. You may install SATA3 hard disks on this motherboard for internal storage
devices. This section will guide you to install the SATA3 hard disks.
STEP 1: Install the SATA3 hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA3 hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA3
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA3 hard disk.
Please be noted that SATA3_A1 and SATA3_A2 do not support RAID
function. If you want to use RAID function on SATA3 connectors,
please use SATA3_0 to SATA3_6 connectors.

2.14 Hot Plug and Hot Swap Functions for SATA3 HDDs

This motherboard supports Hot Plug and Hot Swap functions for SATA3 in RAID
/ AHCI mode. AMD SB950 and ASMedia ASM1061 chipsets provide hardware
support for Advanced Host controller Interface (AHCI), a new programming interface
for SATA host controllers developed thru a joint industry effort.
NOTE
What is Hot Plug Function?
If the SATA3 HDDs are NOT set for RAID configuration, it is called "Hot
Plug" for the action to insert and remove the SATA3 HDDs while the system
is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has been
installed into the SATA3 HDD.
What is Hot Swap Function?
If SATA3 HDDs are built as RAID 1 or RAID 5 then it is called "Hot Swap"
for the action to insert and remove the SATA3 HDDs while the system is still
power-on and in working condition.
46