External Connectors - Asus P2L-B User Manual

5. External Connectors

WARNING! Some pins are used for connectors or power sources. These are
clearly separated from jumpers in "Map of the ASUS Motherboard." Placing
jumper caps over these will cause damage to your motherboard.
IMPORTANT: Ribbon cables should always be connected with the red stripe on the
Pin 1 side of the connector. The four corners of the connectors are labeled on the
motherboard. Pin 1 is the side closest to the power connector on hard drives and some
floppy drives. IDE ribbon cable must be less than 18in. (46cm), with the second drive
connector no more than 6in. (15cm) from the first connector.
1. Keyboard Connector (KB-PS2KB, 5-pin female)
This connector supports either a standard IBM-compatible, 101/102-key, or 104-
key keyboard (Windows 95-compatible). Use a PS/2 keyboard adapter in order
to connect a PS/2 keyboard to this AT connector.
P2L-B Keyboard Connector
2. Floppy drive connector (FLOPPY, 34-1 pins)
This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).
P2L-B Floppy Disk Drive Connector
26
III. INSTALLATION
R
Keyboard Connector (5-pin female)
This motherboard accepts an AT Keyboard
Connector Plug as shown here.
Pin 1
Floppy Disk Drive Connector
R
ASUS P2L-B User's Manual