Asus P2L-B User Manual page 21

III. INSTALLATION
2. Mount the Heatsink: Place the SEC cartridge face down on a flat surface and lay
the heat sink flush on the back (metal side) of the SEC cartridge. Check the orien-
tation of the heatsink against the pictures. The thicker fin must be orientated
toward the bottom. The top clamp is wider than the bottom clamp so only this
orientation will fit. With a screw driver, push the clamps one at a time into the
SEC cartridge. Be sure that the heatsink is firmly pressed against the SEC car-
tridge. When correctly installed, no light must be showing through between the
thermal pad of the heatsink and the SEC cartridge.
WARNING! If the heatsink is not mounted tightly against the SEC cartridge,
the CPU will overheat. You may install an auxiliary fan to provide adequate
circulation across the processor's passive heatsink.
(9)
(8)
Push Clamp
Push Clamp
SEC Cartridge with Heatsink (Side View)
3. Insert the SEC Cartridge: Push the SEC cartridge's two locks inward (the
preceding picture shows the locks in the outward position and inward in the
picture below). With the heatsink facing the motherboard's chipsets, press the
cartridge gently but firmly until it is full inserted.
(8)
Push each end of the clamps until they lock
(8)
(9)
The thermal pad & SEC cartridge should not have a gap!
SEC Cartridge with Heatsink (Top View)
(9)
ASUS P2L-B User's Manual
Push lock inward
(3)
21