Asus P2B User Manual page 15

III. HARDWARE SETUP
Set the jumpers by the Internal speed of your processor as follows:
Intel CPU Model Freq.
Pentium III 550MHz
Pentium III 500MHz
Pentium III/II 450MHz
Pentium II 400MHz
Pentium II 350MHz
Celeron 466MHz
Celeron 433MHz
Celeron 400MHz
Pentium II/Celeron 333MHz
Pentium II/Celeron 300MHz
Pentium II/Celeron 266MHz
Pentium II 233MHz
For updated processor settings, please visit ASUS' web site (see ASUS CONTACT INFORMATION)
NOTES: Overclocking your processor is not recommended. It may result in a slower
speed. Voltage Regulator Output Selection (VID) is not needed for the Pentium III/
II/Celeron processor because it sends a VID signal directly to the onboard power
controller.
(BUS Freq.)
Ratio BUS F. FS0 FS1 FS2
5.5x 100MHz [1-2] [1-2] [1-2]
5.0x 100MHz [1-2] [1-2] [1-2]
4.5x 100MHz [1-2] [1-2] [1-2]
4.0x 100MHz [1-2] [1-2] [1-2]
3.5x 100MHz [1-2] [1-2] [1-2]
7.0x 66MHz [1-2] [1-2] [2-3]
6.5x 66MHz [1-2] [1-2] [2-3]
6.0x 66MHz [1-2] [1-2] [2-3]
5.0x 66MHz [1-2] [1-2] [2-3]
4.5x 66MHz [1-2] [1-2] [2-3]
4.0x 66MHz [1-2] [1-2] [2-3]
3.5x 66MHz [1-2] [1-2] [2-3]
ASUS P2B User's Manual
(Freq. Ratio)
BF0 BF1 BF2 BF3
[1-2] [1-2] [1-2] [2-3]
[2-3] [1-2] [1-2] [2-3]
[1-2] [2-3] [1-2] [2-3]
[2-3] [2-3] [1-2] [2-3]
[1-2] [1-2] [2-3] [2-3]
[2-3] [1-2] [2-3] [1-2]
[1-2] [2-3] [2-3] [1-2]
[2-3] [2-3] [2-3] [1-2]
[2-3] [1-2] [1-2] [2-3]
[1-2] [2-3] [1-2] [2-3]
[2-3] [2-3] [1-2] [2-3]
[1-2] [1-2] [2-3] [2-3]
15