Download Print this page

Dynex DX-37L150A11 Firmware Update

Tuner firmware update process.
Hide thumbs
   

Advertisement

Tuner Firmware Update Process for Dynex Model DX‐37L150A11 
 
1. IMPORTANT: Please completely read these instructions prior to starting your
update process.
2. Determine the proper Rev id by looking at the sticker on the side of the TV (see photo
below) and write down the Model and Rev id for use later in this process.
3. Insert USB drive to your PC or Mac
4. USB drive being used must not have any folders or additional files on the device.
5. Download the firmware that matches the Model and Rev id of your TV.
6. To download firmware click on the "Support/Downloads" tab; then locate the
corresponding Rev id of your TV.
7. Click on the firmware link titled "LC37KS70AUO.Bin" when the pop up box appears
select "Save" and choose the destination of your USB drive.
a. Note: Do
b. Note: This file is <5 Megs in size; download time should be less than 1 minute.
8. Once down load is complete safely remove your USB drive.
9. Disconnect the AC power from your wall outlet for the TV
10. Insert USB device into the SERVICE PORT; located in one of 3 places, back, side or
bottom. The correct port will be labeled either Service or Service/USB. See photo below
NOT
change the name of the file.

Advertisement

   Related Manuals for Dynex DX-37L150A11

   Summary of Contents for Dynex DX-37L150A11

  • Page 1

    Tuner Firmware Update Process for Dynex Model DX‐37L150A11    1. IMPORTANT: Please completely read these instructions prior to starting your update process. 2. Determine the proper Rev id by looking at the sticker on the side of the TV (see photo below) and write down the Model and Rev id for use later in this process.

  • Page 2

    Note: If the process takes more than 5 minutes, that means the upgrade failed. Please remove the file from the USB drive and repeat the process. b. If the upgrade fails again contact Dynex at 1-800-305-2204. 14. The upgrade is complete when the “Please Wait...” message disappears 15.

Comments to this Manuals

Symbols: 0
Latest comments: